Originally Posted by
Grumph
Given that the price of chromium hasn't gone up by very much, the differences are in the grinding.
Way back, he had an in house guy doing the grinding. I believe there was a falling - out and for a while he wasn't doing stanchions.
I have no idea who's doing the grinding now or what standard it is. The original setup didn't allow for grinding the full length in one go so you got a result where you could see it had been done in several short sections.
Ideally you want them done on a centerless grinder by someone who knows what they're doing and can measure to high standards.
Do your research before deciding who does your forks.
Find an outfit that does reconditioning of hydraulic rams, eg http://www.jonelhydraulics.co.nz/hyd...der-servicing/
it's not a bad thing till you throw a KLR into the mix.
those cheap ass bitches can do anything with ductape.
(PostalDave on ADVrider)
Bookmarks