Compliance issues

[Dadpole]

This is a call to all for any advice on getting my TS185ER back on the road. The block is brake (drums) measurement. I was told I need the original factory specs for comparison, The problem is nobody seems to have them in a form that is acceptable to VTNZ. I find the numbers online in copies of workshop manuals but nothing factory or dealer linked that I can give them.
The dealer can't help as they have nothing for something from 1990 and they will not do the measuring as there is no reference info. I can do the strip and measure (with photos) myself but the lack of provable factory spec is the point where it all stops.
Anyone out there with any suggestions - other than buy one already registered?

[jellywrestler]

an original shop manual should specify it I would have thought???

[jellywrestler]

how worn are they? what are the part numbers, i have a cross reference parts program that will show what other models they fit, and help widen your search, and maybe find a manual with the specs in them? is it not stamped on them like it is with discs in many cases?

[Dadpole]

No measurements stamped on the drum. The word is that the factory/dealer service manual will do it, but I can't find one. Only the online version and it does not mention run-out limits. I could print that out and have a go I suppose. New linings, so that part is covered.

[neels]

Is this not enough from the factory service manual to keep them happy? If you've inspected as per the instructions and it's all good then surely that should be sufficient to keep the VTNZ people happy?

[Dadpole]

That (above) is what i have so far. I will have to try with that lot and photos & measurements and see if that is enough. A while back pre-91 bikes did not need this. No idea why it changed.
I will take it in in the next week or so and let you all know how it goes.

[neels]

That (above) is what i have so far. I will have to try with that lot and photos & measurements and see if that is enough. A while back pre-91 bikes did not need this. No idea why it changed.
I will take it in in the next week or so and let you all know how it goes.

If you print the book (I'm sure it will be useful in the garage later anyway) and take it along you can demonstrate you have measured everything the factory service manual specifies to be measured, can't see what else they could require you to do, but it is VTNZ so who knows.

You mentioned run-out in a previous post, that's generally specified for disc rotors, if the service manual doesn't provide a spec for the drums then there's nothing to measure to.

Nice to hear of another old bike getting back on the road.