Anyone 1 modded their minimoto ?

[The Beast]

Some people use the 4 petal reed valve, I have tried this and in my experience they were shit, there was an air leak. But others that have used them have found them good. Otherwise standard, you can buy CF reeds also, but the difference will be minimal.

The "RZ6" is what most Pocket biking kiwi's know as the B1 replica. And yes, it is a good bike. Considerably better than the air cooled bikes. A lot faster and WAY better build quality.

[Mattyc]

Thanks Beast

we ditched the rubber seal on the reeds and vee'd the carb side of the
reedblock and port matched it to the inlet manifold with the mighty dremel -

have you got a pic of a 4 petal reed block ?

How much for the jets for the flatslide carb ? the one that we had was 0.9mm

So that watercooled bike is ok, I may buy one for myself to look stupid on..

Whens the next race ?

what premix are you guys running in the aircooled ones ?

[The Beast]

Yes that is good aswel. Apparently the bottom of the carb needs to be re-threaded to fit the jets, because they are made for the B1 rep carb which is only SLIGHTLY different to the conversion kit carb.

The jets come as a set. I'm not sure of the price, but I'll post it up later when I can find it.

We mix our own fuel, 25:1 while running the engine in and then about 30:1 for a while then on to 35:1. The manuals say after the bike is run in, you can use 50:1, but we think that's too lean and 40:1 would be the highest you should go.

Cheers.

[Mattyc]

whens the next race?