frequent infrequenter
who's good at it (either on the site or shop), like, really good?
For the gixer, the right rear set and the pillion peg/exhaust mount (else I wouldn't bother) are bent and need bendin back. Can be done, but I don't have the tools aside from a big hammer, and I don't want to damage the frame it's attached to, or the paint on it.
More importantly, the lower triple clamp is bent, that needs bendin back into shape.
suggestions?
C'mon lets ride....
Any chance of a pic?
frequent infrequenter
this one ok?
it's not mega bent, and a cam won't really show the degree of it.. never mind showin it off tho, if you're interested
C'mon lets ride....
The bike you big tit!Originally Posted by bugjuice
this one ok?
it's not mega bent, and a cam won't really show the degree of it.. never mind showin it off tho, if you're interested
Forum whore
Well, personally, I thought it was quite a miserable little tit. Mr Spankme does a much better line in tits.
C'mon lets ride....
Maybe the resident supporter of lost causes can look after this one........
Unknown Disorder
You could try Bruin Engineering. Tjebbe does a bit of bike straightening
ph 480 9408
Forum whore
you wanna get yourself one of these;
For whom the bell tolls
try Wheel and Frame NZ down in Cambridge. Failing that, ebay is your friend, but you should know that already. Dont forget to try the .co.uk and .com.au aswell.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
Forum whore
hammer and bend to keep shape... heat can too. worked for a fragile ti exhaust system....
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks