Camera/detector mount

[ArcherWC]

Finally got around to getting the mounting sorted for the camera and Detector.

Double top tech mount with the Camera attached using the tripod/stand hole

Vid to come

[crashe]

But why????????????

You wont be using it for some time..........



Mind you, the detector may have helped you out in the past aye








(pt)

[ArcherWC]

But why????????????

(pt)

Camera for track days,


and i already had the detector mounted (just after the ticket that put me over the points limit)

[ArcherWC]

Small Vid

http://www.gr81.co.nz/misc/files/Nana.wmv

[Squeak the Rat]

Small Vid

http://www.gr81.co.nz/misc/files/Nana.wmv

There was a bit of traffic on that track......

[Swoop]

As a suggestion...

The screw in the base of the camera is for mounting it onto a tripod. Tripods do not have to put up with excessive bumping around, etc.

Rather than relying on just the tripod screw in the base of the camera, try drilling 4 holes in the mount plate, around the base of the camera. Through these holes, run 2 short lenghts of bungy cord (most boating places have this in different sizes) knotted both ends (with the knots UNDER the plate). This should leave you with two loops of bungy sticking up above the plate, which you can lift up and place over the camera. Much more stable and strong also!

[ArcherWC]

There was a bit of traffic on that track......

LOL, taken the morning i lost my licence

[Squeak the Rat]

LOL, taken the morning i lost my licence

Bugger - Didn't you see the car flash it's lights??????

[samwp]

Dude! rip off yer plates and pull a ghost rider! I'll join you, try to keep up eh? oh yea and when you work out a good track round the motorway post it here so everyone can spectate

[ArcherWC]

Bugger - Didn't you see the car flash it's lights??????

Yeah I saw it, and slowed down, but no copper anywere.
I wasnt picked up for speeding when i lost my licence, just a so called "licence check" at which point it registered that i was over my demerit point limit