Chopper conversion

**Waylander** · 11th May 2007, 20:08

Originally Posted by dyers

Cool thanks

Just been talking to a friend who drives pocket and pit bikes. Here's my ideas shown in these attached

First pic shows the cone muffler ends that can just be taken off by undoing a screw on each under the bike as they slide on and off.

The next two show what I want.. two stainless steel pipes that will slide on and off like the cone ones. Just they will have no baffles.

Perconally I think you should have them a little closer together than that. Maybe have them run paralell to each other at the same angle asthe lower one.

**The Lone Rider** · 11th May 2007, 23:08

I don't think they will be too spaced from each other. Gotta remember that it is almost like replacing the end pieces with more of the exact same - they just will be thick pipes rather then cones.

Also I can't run them straight without

1. Modifying the piping that the slip onto
2. Making the stock pipes no long able to slip on when its WOF time.