Electrical question

[kro]

If I have 6 x 1.2v batteries, and run them in series, I get 7.2v, that bit I understand. Each of these cells is 3500mah, so when in series, does the mah tally up, and become 6 x 3500?, or does it stay 3500?.

I'm making some lights for my mountain bike, and this is holding me up.

Thanks troops.

[thehovel]

Batteries in series the volts add BUT the ampHours stay the same. regards Richard

[Ixion]

Yuff. You need to put them in parallel for more amphours. You can do both, but then you'd need 36 cells !

[kro]

Thanks troops, I appreciate the replies.

[doc]

Thanks troops, I appreciate the replies.

"Ohms Law" still works huh ! Electronics has changed nothing. Sort of like the Waitangi Treaty.

[johnnyflash]

why not just purchase a recharcable 6v lead acid sealed /rechargable battery and strap to bike frame.. runs around 4.5AH less than $20

[raster]

why not just purchase a recharcable 6v lead acid sealed /rechargable battery and strap to bike frame.. runs around 4.5AH less than $20

Be easier to handle too!

[kro]

Some of the guys I ride with use them, and they are big, bulky, and square, and I was wanting to try something more streamlined. If I move to D size cells in NiMH, I get 7ah, so that's looking even better.

[sAsLEX]

Some of the guys I ride with use them, and they are big, bulky, and square, and I was wanting to try something more streamlined. If I move to D size cells in NiMH, I get 7ah, so that's looking even better.

So instead of being the above and square they are round?

[avgas]

Or you could have done what i did and ran 4 10mm 10,000 mcd superbright leds. You can ramp up/down the current between 14-120mA for brightness. But the suckers take about 4v each.