Put a new tail on the zxr

[Coyote]

It's looking pretty damn good

Nice graphics on the side fairings

[Coyote]

Is it fibeglass? Hope so, it'll be cinch to match it up to the tank if it is

Sounds good in theory, could make the tail itself look a bit funny

[imdying]

And having that unused mount on the bottom of the tank just hanging around by it's little lonesome doesn't look funny?

[skidMark]

Is it fibeglass? Hope so, it'll be cinch to match it up to the tank if it is

yeah it's fibreglass

[skidMark]

And having that unused mount on the bottom of the tank just hanging around by it's little lonesome doesn't look funny?

cld make it into a crash bung mount LOL

[Qkchk:Me]

Heaps better than that gay paddle you had on the back yesterday.............

[ZeroIndex]

looks good dude...

[LilSel]

Looks sweeet

[imdying]

yeah it's fibreglass

Awesome... you should be able to mold that bit along the bottom of the tank pretty easily... if it were me, I'd take a mold off the original tail piece where it meets the tank, then make enough of that part to mold into your new bit, then mold them together... bit of sanding and paint, and you're done!