For whom the bell tolls
almost got the beast done. Just need new brake disc for rear, pads all round, Front indicators, fix front brake light switch, carb tune, vin and rego!
so basically just $$$
all the same, rather close to completion, all going well im aiming for my birthday (30th November) or at worst xmas.
looking very sexy with the chrome exhaust system, any ideas on how i can re-sleeve the can???
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
Hardcore Biker
Seen carbon fibre sleeve, which slips over the top.Originally Posted by gareth_d
Would be piss easy to fabricate stainless one.
For whom the bell tolls
only problem is that the holding bracket (from can to frame) is on the sleeve... and im not a great welder.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
_______________
My bracket is like this
For whom the bell tolls
i've thought of that, my can is an aftermarket bolt on system, so it needs to be fixed steady, cant have any lateral movement or she might pop off...
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks