Just a notice about Paekakariki Hill Road. The lower section has been re-sealed today. Lots of fine gravel sitting on top so beware.
G.
Just a notice about Paekakariki Hill Road. The lower section has been re-sealed today. Lots of fine gravel sitting on top so beware.
G.
thought you were talking about puke there for a sec.
Thanks for the heads up Groins. But, I'm not surprised. That road ALWAYS has something on it which requires dodging, or some other manouvre! IF, IF it was as reliable as the Takas, it could be an awsome road. But, sadly, I don't think I'll ever go "hard" on there.
any1 want to race me on my z50 thru there?Originally Posted by Groins_NZ
heaps better than the Takas.... hardly ever diesel on Pi-Cock!!!!Originally Posted by StoneChucker
went over the kiami's the other day.. they are re-sealing what they re-sealed just before Xmas.... which is the same place they re-sealed about 2 months befroe xmass... wish i was the owner of the chip suppliers!.....
just need to send up a road sweeper then resell back to transit every couple of months!![]()
![]()
![]()
![]()
![]()
![]()
![]()
what a ride so far!!!!
get a bike that don't need no stinking seal.... you'll be searching out all the road works then.....
You're on!Originally Posted by JohnnyRotten
So where is this hill then?
If you think you're man enough for a shot at the title then I'll race you. I'll bring a cut lunch so I can have something to eat while waiting for you at the top.Originally Posted by JohnnyRotten
Better bring the whole friggin picnic basket for all of us waiting at the top. Maybe a sleeping bag too. (pt)Originally Posted by jimbo600
Ha good one.Originally Posted by Andyadams
![]()
Just went over and back on it this arvo and its not all that long of a bit on the easy part of the road (the new seal that is) - the real tight stuff was actually more gravel free than I've seen it in a while they must have swept the curves as often there is just a little bit of loose crud that has fallen off the cliffs at the corners, but not today.
Cheers
Merv
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks