2001 cr250 swing arm

[flyingcr250]

does any one know were i can get a secondhand swing arm for my 2001 cr250. mine is a bit reamed out were the bearing fits in on the chain side. it only moves a bit but its enough to make the bike feel funny in a straight line.

[cheese]

have you called Econohonda? Or eBay would be a good place to try.

[flyingcr250]

just priced it up with honda $1595 bucks ex japan. just another big bill ha ha ha

[theblacksmith]

just priced it up with honda $1595 bucks ex japan. just another big bill ha ha ha

Welding and machining an option maybe, or if theres enough meat u might be able to get a bush in there - if you have trouble finding a 2nd hand one.
Ive done more complicated jobs - have u got a fairly close up image of it?

[flyingcr250]

no i dont, its still on the bike, i tried using a bearing housing repair cement from loctite but it didnt last. a bush could be an option, ill have to have a look next time it comes off the bike. i dont think id trust my boss to make something that accurate. hahaha

[cr125nz]

farm and trail in teawamutu they have a couple on there shelves when i had to pik up a chain guide for my bike hope this helps

[vr4king]

Ive seen one welded then machined out came out mint def an option id look at

[theblacksmith]

farm and trail in teawamutu they have a couple on there shelves when i had to pik up a chain guide for my bike hope this helps

There you go mate! Bingo! Dont mention the ex-japan thingy to them lol
Their tel no is= 07 871 4953

[CRF119]

Weldina machining works i brought a CR125 that somebody had worn through the chain gide welded and machined good as new.

[flyingcr250]

cheers for the ideas. it should be ok for kimmys over the summer, i think the best thing to do is not look at it. ha ha ha.

[cr125nz]

so you are that guy lol

[flyingcr250]

yea i also have a small crack in my barrel, dave at boyds told me not to think about it when im riding ha ha ha