Bent flywheel EEK! Rebuild advice required hehe

[Leyton]

Hello

My bike just cutout whilst on turn 3 at Mt Wellington along the short steight . WAM! Off it went and the engine rev'ed down. I knew it was not seized thank goodness! And I suspected coil imediately as I was walking it back to the pits

Symptoms are : No spark + Bent Crankshaft

Some how the crank is bent, I have no idea how yet! hehe but all I know is for now I will need to replace it and all ralivant seals

Is anyone able to point me in the right direction for getting a new crank and all relaited seals to do the bottom end ?

I will measure up the bearings do them too while I am at it

Cheers in advance!

I will take photos throughout the crank replacement with some handy advice, It would be great if those who have done this before could contribute to the knowledge pool

Leyton

[Ray LeCheminant]

Hi Leyton , nice to finally meet you yesterday.

Greg from XMINIMOTO.CO.NZ has cranks in stock I believe....

email him on greg.o@xtra.co.nz

Regards

Ray

[Leyton]

Cheers dude and likewise! See you at Tamruanui fingers crossed