I need a 99 CR250 swing arm.

**krasher** · 9th May 2009, 10:35

Any ideas? Anyone got one laying round?

I got this bike for dad for his bday but the swing arm bearings and linkage bearings are stuffed and so stuck that an engineer can't get em out.

I am pissed off that the guy who sold it to me didn't know - or say - they were stuffed and just sold it like that. Not to say it's not my fault for checking more thoroughly.

Anyway - I need to get it sorted. Alternatively. What is the bike worth without these parts? Anyone need a good motor/clutch/fork/wheel parts?

It owes me 2k. If I even get $1500 for it I would be happy at this stage.

**hayd3n** · 9th May 2009, 11:14

can you not heat up the swing arm or even drill them out surely there is a solution maybe a really good press

**cheese** · 9th May 2009, 11:51

Are the bts you press in stuffed or just the bearings? If its only the bearings, you should be able to save it. Otherwise call Econohonda.

**krasher** · 9th May 2009, 12:34

It's all stuffed. Rusted/corroded in. Swing arm started to crack when heated so the left it.

Econohonda. I'll call em.

PS The work was done by an engineering shop. I can only assume they know what they are talking about when they say its more trouble than it's worth.