I am in the process of doing valve clearances and rocker cover gaskets on the NC30, and I need 11 new shims.
Managed to swap a few around to get them in spec, but I am after:
3 x 220
7 x 225
1 x 230
The local Honda shop sells packs containing 5 of a particular size listed at $15 for the pack, which isn't too bad, but it means I'd have to buy 4 packs to cover the sizes I need, and I'd have 9 shims left over afterward.
Just wondering if anybody knows of a shop around Hamilton that will trade shims, or sell single shims? I don't really wanna buy a pack of 5 when I only need one of a particular size.
Any of you lot still riding your NC30s? I feel like I haven't seen any on the road in forever!
Not there yet, still rocking a clapped out old nc21.
Sent from my Nokia 6.1 using Tapatalk
Heinz Varieties
Skidmark. Remember that prick?
Don't you look at my accountant.
He's the only one I've got.
Anyone got a busted old bike they want to sell? I need a new project.
HenryDorsetCase you still got that old race bike with bad compression?
Tank, wheels/tires, chain are good condition. Has new piston rings & engine gasket
Fairings are alittle worse for wear (the tail fairing is cracked for instance)
The main reason I've decided to give up on the rebuild is crank bearings need replacing & not easily available
The bike has done around 90,000miles & is starting to show it
Money wise I'd *like* $4k so I can buy a DRZ400 but I'm not expecting that, I'd be happy with $1400, as parted out should be able to get that easy enough, but open to offers; price is in no way stone set
Flick me a message if you want to view or anything.
Science Is But An Organized System Of Ignorance"Pornography: The thing with billions of views that nobody watches" - WhiteManBehindADesk
And the last thing you need is another project.
Don't you look at my accountant.
He's the only one I've got.
Ooh, standard KB going rate is $5 and a bag of chips.
Don't you look at my accountant.
He's the only one I've got.
I have an NC30 that is bit of a project (fairings are a mix of original, fiberglass, and chinese plastic and different colours). Approx 90,000km. Engine has new big end and crank bearings. Valves shimmed by honda.
Last road it approx 2 years ago and ran fine. Has a few spares with it (mainly a set of heads).
Reg on hold.
Looking to off load it in the near future if anyone is interested.
There are currently 2 users browsing this thread. (0 members and 2 guests)
Bookmarks