I supply and install Mitsubishi Electric ( as opposed to Mitsubishi Heavy Industries). They are very good if sized and installed correctly.
Older heatpumps run on R22 and compared to the newer R 410a and are junk.
I ( foolishly) when working for York bought Luxaire (Warehouse) units....they are rubbish...anything below 10 degrees and the heat output is pathetic.
Still...they were cheap but you forget the cost when something does not work properly.
Mitsubishi....I have measure 50 degrees plus air off with a frost outside.
Installation: make sure your installer at least has a vacuum pump...if not it voids the warranty.
Pipe work should be pressure tested and vacced to under 500 microns to ensure long compressor life.
Larger units should have a dedicated power circuit.
Only a registred electrician can install new fixed wiring, and supply a Compliance Certificate.
Bookmarks