Help - cost to fix my bike?

[quallman1234]

Sad but true, that would work!

Hmm not the same as the RG150 one's. Was there rubber's and stuff?

Should be able to bend it back easily.

[gummibear]

Tried the hammer+vice, worked a treat! Backup option sounded good too though. Horns going too now, all I did was crc it and recheck all the conections, then try it again. Headlights were easy too, but now i'm worried about something else. Today I started it and was keeping it at 3000revs, then all of a sudden it would jump up to 7000 by itself, i wasn't moving the throttle at all. This happened a few times, then I turn off the bike for a bit and went away, but when I tried to start it again later, it started but when I tried to rev it, it would stop. Surely its not because I unscrewed the bar weight? Have I just completely broken my baby

[325rocket]

cable issue maybe?

[quallman1234]

Was the choke on when you did this?

[Ixion]

Did you rmeove the handlebar to hammer and vice it? If so, recheck the run of the throttle cable, and all screws etc.

[gummibear]

yes, i was using the choke, and i did remove it before hammering too