Where do I screw?

[jetboy]

Hey guys,

I was about to go for a ride yesterday so wheeled the bike out of the garage and started it, but when warm it had trouble holding any sort of revs. Upon closer inspection I found the idle adjustment screw was flopping around and not screwed in


After a bit of reading on the net it sounds like this is the solution to my problem, but where does it screw in?

What do I need to? I am aching to go for a ride!

Cheers,
Tim

[MSTRS:Me]

I seem to recall another thread about this quite some time ago. Not easy getting the screw back in it's hole...and I think it was a CBR250-type as well.

[cs363]

Hey guys,

I was about to go for a ride yesterday so wheeled the bike out of the garage and started it, but when warm it had trouble holding any sort of revs. Upon closer inspection I found the idle adjustment screw was flopping around and not screwed in


After a bit of reading on the net it sounds like this is the solution to my problem, but where does it screw in?

What do I need to? I am aching to go for a ride!

Cheers,
Tim

There's some diagrams on this thread which might help, seems it's a not uncommon issue... http://www.kiwibiker.co.nz/forums/sh...ad.php?t=79129

[jetboy]

Perfect, thanks guys. Works a treat now!

[sunhuntin]

im really shocked you didnt get any smart arse replies given the title of ya thread, lol.

[cs363]

Perfect, thanks guys. Works a treat now!

Sweet, hope you get some nice riding weather tomorrow

[cs363]

im really shocked you didnt get any smart arse replies given the title of ya thread, lol.

I thought about it, but it would have been too easy....

[jetboy]

The point of the title was to get peoples attention haha

Thanks again guys!