Manawatu Rant n Rave

[cowboyz]

takes more than a meanie doing his nut at some servo to embarass me.......

[ducatilover]

Would riding with a turbo honda embarrass you by being so gay?

[banditrider]

Would riding with a turbo honda embarrass you by being so gay?

Paint it green and she'll be jape.

[ducatilover]

Paint it green and she'll be jape.

Hell no!!!! Dark metallic red for me

[Owl]

Would riding with a turbo honda embarrass you by being so gay?

CX500 Turbo = I'm terrified

Somehow I'm guessing it's not a CX500?

[ducatilover]

CX500 Turbo = I'm terrified

Somehow I'm guessing it's not a CX500?

No..... Mine is gayer. And incomplete grrr I'm not getting the flanges as fast as I want

[cowboyz]

Would riding with a turbo honda embarrass you by being so gay?

Ithink you are overestimating my self worth. I recently rode 750km in a honda shirt. I have no dignity!

[86GSXR]

Are there any pictures of this turbo charged Honda?

[ducatilover]

Ithink you are overestimating my self worth. I recently rode 750km in a honda shirt. I have no dignity!

Even I wouldn't do that

Are there any pictures of this turbo charged Honda?

Wait till it's done, then I will get the pics. No camera right now The set up is being assembled on my spare motor so I can basically throw most straight on

[86GSXR]

Sounds very interesting..........

[ducatilover]

Sounds very interesting..........

I can write up the details if needed. I'm still searching for all the little bits, eg an4 stainless hose fittings grrr. I need a tee to be put in the oil pressure switch hole to connect to the turbo oil supply but let me still see if I have pressure [quite handy that oil stuff]

[86GSXR]

No pressure for a write up unless you want to. Post up some pics when you get your camera and bring her over when she's up and running. Good luck with finding the bits

[ducatilover]

No pressure for a write up unless you want to. Post up some pics when you get your camera and bring her over when she's up and running. Good luck with finding the bits

Cheers!

Quick run down so far,
Mighty extractors that are rather annoying to make. toyota c12a from a jzz30 soarer
I cut down a Nissan silvia intercooler and am making end tanks from panel steel. cooler measures around 70 wide 70 thick and 160 [ i think] tall.
Obviously different jets. May need to fit a fuel pump, not too sure yet.
Modified the spare air box to fit intake pipe. Oil line as mentioned from pressure switch, returns into a custom made oil filler cap using an4 stainless lines [may have to go an6 due to fittings availability, hope not though]

That's all so far. Will have to put a thread on the waste gate actuator to make it run a measly 4psi

[86GSXR]

I like it

[ducatilover]

It's all based on the metalspeed.co.jp spada in my avatar. Except mine is being painted dark candy apple and a black frame + the cbr400 fairing, which I have made proper mounts for Nz's silliest 250 chasing 40hp at the wheel.