I was just having a look at MCNZ bucket racing regulations and noticed that the minimum wheelbase for a bucket is 1300 mm. Has anyone bothered to measure there bucket to see if theres meets regs?
Moped rider
I was just having a look at MCNZ bucket racing regulations and noticed that the minimum wheelbase for a bucket is 1300 mm. Has anyone bothered to measure there bucket to see if theres meets regs?
Moped rider
I see the FXR comes in at 1325mm but the Cbr 125/150 is 1285mm.
Forum whore
I havent got any where near 1300 M&M'sOriginally Posted by Hazzard
I keep eating them
just chect and it's posible that F5Dave only has 1260 mm wheel base
goes for DD as well and Nigel
"Instructions are just the manufacturers opinion on how to install it" Tim Taylor of "Tool Time"
“Saying what we think gives us a wider conversational range than saying what we know.” - Cullen Hightower
Norf Welly Massif
That's for bucket sidecars isn't it?
The Unknown Rider
Forum whore
better be
"Instructions are just the manufacturers opinion on how to install it" Tim Taylor of "Tool Time"
“Saying what we think gives us a wider conversational range than saying what we know.” - Cullen Hightower
Moped rider
Yes having another look you may well be right. Without scrolling down from above rule 24 2-7-2 reads ambiguously sorry.
Norf Welly Massif
24-2-7 Construction of Sidecars:
Miniature road race sidecars are to be constructed in accordance with the following:
24-2-7-1 Wheel Track:
This shall be minimum of 650mm, maximum 1120mm. The front and rear wheels must
not be more than 70mm out of alignment of a straight line at right angles to the rear axle.
All measurements are taken at wheel centrelines.
24-2-7-2 Wheel Base:
Rear axle centre to front axle centre - min. 1300mm, max. 2000mm.The sidecar wheel
axle shall be between the rear wheel axle and the middle point of the wheelbase.
The Unknown Rider
No8 Wire Extraordinaire
Std RG50 would likely fail too if it were for bikes, but yeah sidecars.
Don't you look at my accountant.
He's the only one I've got.
Making James May look quick...
We'll protest the blardy things on Sunday then
Sometimes you wish it was easier, but if it was, everyone else would do it, then you remember you don't want to be like everybody else!
Very controversial
i think my bike is okay, my exhaust is under the bike, but its been done by custom chambers...so should be legal
a dont think JC would inforce this rule.....unless the bike is a hazzard
chuck norris's calender goes from march 31st to april 2nd
No one fools chuck norris.......
bucket blingster
errrr why would your fitment of an exhaust make any difference to your wheelbase?
No8 Wire Extraordinaire
Who can tell? he still hasn't picked up it isn't a bike reg anyway.
. . . what about if I had too many tank stickers? would that affect the width limit? Think the law is 500mm from center line of bike. At least I read that somewhere. Must apply to buckets as well
I think my tyres are under depth limit as well.
Don't you look at my accountant.
He's the only one I've got.
Moped rider
Ive really got to stop drinking during the week and think that i can read rulebooks
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks