Anyone know where i can buy one of these babies from? And what kinda of price is it? I hear the insert tool is quite expensive. Any other alternatives?
Cheers
125GP!!!
Anyone know where i can buy one of these babies from? And what kinda of price is it? I hear the insert tool is quite expensive. Any other alternatives?
Cheers
No8 Wire Extraordinaire
A bearing or engineering shop. Saeco is a good start, but so is Paykels near TSS & probably trademe. Tool comes with a few inserts. Yes expensive but always on the shelf & you're likely to need M6 & M8s probably 5s later in life. Any decent engine reconditioner will do the job for you at a cost.
Don't you look at my accountant.
He's the only one I've got.
Hardcore Biker
Try Engineering Supplies in Petone also. They may seem expensive kits but, if used with care, are alot cheaper than the alternatives.
Life is a lesson-if I bother to listen
125GP!!!
Cheers y'all sorted.
Its for a brake caliper btw.
2 weird 2 live, 2 rare 2 die.
You can make a tool easy enough if you just want to buy the inserts..
A bolt/cap screw/random bit of round bar that fits into the heli insert with a hacksaw/grinder cutoff wheel slice in it will do.. At a fraction of the price.
Originally Posted by sil3nt
No8 Wire Extraordinaire
It's the tap that costs the money
Don't you look at my accountant.
He's the only one I've got.
Forum whore
Maybe you could make one of those too.
2 weird 2 live, 2 rare 2 die.
Its been done.. Limited use only though.
No8 Wire Extraordinaire
. . . And ideally if cheese is your subject medium to tap.
Don't you look at my accountant.
He's the only one I've got.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks