Wtf is wrong with my GN250?

[Drew]

What is wrong with you people. She says something is wrong with her GN and you'all tell her to swap her bikes for a new bike

We offered some random advice first fuck ya.

....and no one here mentions this http://www.trademe.co.nz/motors/moto...-579201736.htm

Good thinking that man!

[Mom]

Sounds like I need to take it to a proper bike mechanic cause my flatty sure as hell ain't gonna help me with this one esp if we don't have whatever the fuck a tappet adjust driver is or the right gauge.

Check that air filter is installed properly. Then check your choke is operating properly, ie, not stuck on.

[T.W.R]

What is wrong with you people. She says something is wrong with her GN and you'all tell her to swap her bikes for a new bike




....and no one here mentions this http://www.trademe.co.nz/motors/moto...-579201736.htm

They're good like that around here

[bosslady]

Check that air filter is installed properly. Then check your choke is operating properly, ie, not stuck on.

Both are fine

[Mom]

Both are fine

Take it out and thrash the bejeejus out of it

[bosslady]

Take it out and thrash the bejeejus out of it

it's actually been awhile since she's had a nice long trip. As for choke, can u define stuck on?

[Smifffy]

it's actually been awhile since she's had a nice long trip. As for choke, can u define stuck on?

Thought you said it was fine? Seemed fairly certain..

Both are fine.

[Mom]

it's actually been awhile since she's had a nice long trip. As for choke, can u define stuck on?

There will be a mechanism on the carb that moves when you pull your choke out and push it in. Stand on the choke side of the bike and look at the carb. Pull the choke out, push it in. Make sure you see the mechanism on the carb moving as you do. I could show you it, but you will see it moving if it is.

[nzspokes]

If the tappet tool you need is the one that goes on the top of the square part of the tappet I has one you can borrow. I also has feelers.

You can borrow but if you stuffem you own em. Mind you it would take an epic muppet to do that.

[bosslady]

If the tappet tool you need is the one that goes on the top of the square part of the tappet I has one you can borrow. I also has feelers.

You can borrow but if you stuffem you own em. Mind you it would take an epic muppet to do that.

all sorted for tools I think thank you

[bosslady]

There will be a mechanism on the carb that moves when you pull your choke out and push it in. Stand on the choke side of the bike and look at the carb. Pull the choke out, push it in. Make sure you see the mechanism on the carb moving as you do. I could show you it, but you will see it moving if it is.

seems to be ok I think

[Drew]

Mind you it would take an epic muppet to do that.

Welcome to KB. Please don't feed the trolls.

Drew.

[jellywrestler]

it says you need a tappet adjust driver? don't have one and I don't think we have the right thickness gauge for what it says in the manual.

grow ya pinky finger nail for four to five weeks on a low carb diet with no red wine and that should be the correct clearance for the inlet, index finger same time diet for the exhaust, you've got, or should have, two hands use one set of nails now and clip the other set off and keep it with your toolkit, make sure you label which one is which

[fridayflash]

...and a ciggy paper folded twice is correct points clearance

[jellywrestler]

...and a ciggy paper folded twice is correct points clearance

I think she's from the north shore, they only smoke cigars up there...