Does anyone know if the wheels + brakes from a 2003 GSXR1000 will swap over into a GSXR750k4/K5?
For whom the bell tolls
Does anyone know if the wheels + brakes from a 2003 GSXR1000 will swap over into a GSXR750k4/K5?
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
Who you gonna call!
Front does but the rear hub is too wideOriginally Posted by R6_kid
Second is the fastest loser
"It is better to have ridden & crashed than never to have ridden at all" by Bruce Bennett
DB is the new Porridge. Cause most of the mods must be sucking his cock ..... Or his giving them some oral help? How else can you explain it?
The Ragin Cajun
correct front is same 300mm dics
rear is wrong since rear on 600/750 = 5.5" where rear on 1000 is 6"
i am sure it will work with some right spacers, but its not straight bolt up.
For whom the bell tolls
Ok, thats that one sorted.
Anyone know if the whole front end will swap over ok?
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
The Ragin Cajun
i would think be fine
the front end of the gsxr 1000 is got heavier springs than say 600/750
brakes from a k3(single pad per piston) is better than the k4/k5 brakes.
i do have a picture chart somewhere showning gsxr fork sizes i see if i can find it and post it up
Who you gonna call!
Neah you will crack the swingarm if you try and "force" it
Second is the fastest loser
"It is better to have ridden & crashed than never to have ridden at all" by Bruce Bennett
DB is the new Porridge. Cause most of the mods must be sucking his cock ..... Or his giving them some oral help? How else can you explain it?
The Ragin Cajun
just did a quick search on gixxer.com
say 6" will fit, just use the spacers that are on the 1000.
attached is a list of the interchangeable rims for the 600/750 k4/5
For whom the bell tolls
Sweetas, was thinking of using the 6'' to run a 190/55 on my mates 750, but it should work fine on the 5.5".
As long as the front end will swap over then our main problem is sorted.
KiwiBitcher
where opinion holds more weight than fact.
It's better to not pass and know that you could have than to pass and find out that you can't. Wait for the straight.
The Ragin Cajun
plenty of people run 190/55 on the 5.5" rims.
Who you gonna call!
Yip they fit fine gives heaps more feedback i reckon.
Second is the fastest loser
"It is better to have ridden & crashed than never to have ridden at all" by Bruce Bennett
DB is the new Porridge. Cause most of the mods must be sucking his cock ..... Or his giving them some oral help? How else can you explain it?
Forum whore
fit fine...heaps more grip!!
Forum whore
Refer my answer to your pm, the GSXR1000 forks are not a good choice due to excess friction in the cartridges ( very poor tolerancing ) and a very poor compression piston. It costs a lot of money to make these forks work to an acceptable standard.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks