Paintjob request

[Shazz]

I am looking at getting a design on my tank, and rear fender.
I have found the one I like but don't know how to go about getting it off the net, getting it printed onto the right paper, and then getting it to a painter.
Any suggestions would be much appreciated.
Any suggestions on where to get a transfer done in the local area would also be great too.
cheers

[Paul in NZ]

To make a printable 'sticker' or transfer you need to find a hi res copy of it on the net because most net graphics are low/med res for fast loading and look 'grainy' when enlarged.

There is a place here in wellie (several in fact) that can make these graphics up on vinyl.

A low res copy is fine if you are going to get it air brushed onto the bike because the artist will be reinterpretting it any way.

Cheers

[Shazz]

thanks for that, much appreciated.
Guy is a tat artist and thinks he can do it ok.

[Pixie]

thanks for that, much appreciated.
Guy is a tat artist and thinks he can do it ok.

He'll need tungsten needles in his tatoo thingy to do a tank

[Attract Promotions]

hahhahhhaah,
Quote of the year!
Tungsten needles indeed