As the topic says. I've looked at Repco and Placemakers and the highest I can find is 1200 Wet/Dry paper.
I live in East Auckland, any ideas where I could go?
Stoke me a clipper!
As the topic says. I've looked at Repco and Placemakers and the highest I can find is 1200 Wet/Dry paper.
I live in East Auckland, any ideas where I could go?
Que?
Engineers Merchants.
Blackwoods/Paykels in Carbine Rd Mt Wellington
Probably a few in East Tamaki too.
Wet & Dry (Silicon carbide) is available up to 2000grit. Not many increments past 1200, maybe goes from 1200 - 1500 - 2000 from memory.
The instructions are simple...
Automotive Spraypainter's supplier
Do you realise how many holes there could be if people would just take the time to take the dirt out of them?
Hardcore Biker
How much do you need, I might have a few sheets at home
Stoke me a clipper!
Next to none - I want to use it to remove scratches on my front sprocket cover , clutch plate cover (not sure of 'official' names) and a couple of other small areas so probably one sheet would do it i'd sayOriginally Posted by Kwaka12R
Deep in the heart...
Most paint suppliers have it by the sheet.
"If you can't laugh at yourself, you're just not paying attention!"
"There is no limit to dumb."
"Resolve to live with all your might while you do live, and as you shall wish you had done ten thousand years hence."
Hardcore Biker
If youre only after a small amount, try the local hobby shops. Will cost a fair amount but they should have it.
I think the phrase rhymes with "Clucking Bell" - Blackadder
madfox
i sell it $1.50 per sheet
Scooter boy
As someone above stated 1500 and then the next one is 2000 grit.
Available from 3M, I'm not sure who they supply it to. You could ask them 0800 200 712 - Product #401Q, wet on dry.
Or get the buy above here to post some
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks