How long should I warm up a CBRR250 before riding off? Should I pre-check anything before or after starting the bike? Should I pre-check anything before I ride off?
How long should I warm up a CBRR250 before riding off? Should I pre-check anything before or after starting the bike? Should I pre-check anything before I ride off?
i ride off as soon as the bike runs properly.You should ensure that your lights work,esp indicator brake and headlight,brakes work and tyres arent low in pressure(ie slow leak).
You can see if the brake light works by seeing if it illuminates a nearby object when you apply brakes (when you test the brakes)You should soon be very familiar with how your bike feels.If something doesnt sound or feel right as you ride off check immediately!
choke on
\turn key
put gloves
take of gloves
put on helmet
put on gloves
get on bike
choke off
clutch in
change into first
stall
put side stand up
pull clutch in
turn key
rev bike gently
slowly let clutch out
and go for a ride
dont rev hard for the first 10 minutes riding
and remember you will have cold tyres
so no knee down action untill they are nice n hot
plastic fabricator/welder here if you need a hand ! will work for beer/bourbon/booze
come ride the southern roads www.southernrider.co.nz
All the gear, all the time.
1. Put all your kit on except your gloves.
2. Sit on bike, jam gloves on top of tank (in plain sight so I dont forget!) and wheel bike outside - listen for strange squeaks, rubbing
2a. Check the weather (do I need to pack my wet weathers?)
3. Ignition on, check brakes & lights, indicators all round (use a reflection in a window to check the back end)
4. Wiggle steering - feel for anything strange
5. Check neutral & light - Kickstand!!!!
6. Start it up
7. Heres your warm up! Check helmet strap, collar and cuffs. Put your gloves on
9. Ride away
As long as you dont tear away from your house, and keep your neighbors happy thats all the warm up you need!
Its normally about then when you go 'shit, forgot my wallet!!'![]()
Cats land on their feet. Toast lands jamside down.
A cat glued to some jam toast will hover in quantum indecision
Curiosity was framed; ignorance killed the cat
Fix a computer and it'll break tomorrow.
Teach its owner to fix it and it'll break in some way you've never seen before.
I think by runs properly he means no strange noise, and bike is warmed up. When bike is cold, the bike feels sluggish, doesn't accelerate much when you twist the throttle. When bike is warm, the bike goes zoooooom when you twist the throttle.
Go to petrol station to check tyre pressure, or your own pen looking tyre pressure checker. Download bike manual for tyre pressure, or others with the same bike as you can advice.
The bike basically warms by itself when you ride.
Go figure. But I wouldn't say the same for two stroke bikes however.
If you can make it on Kiwibiker you can make it anywhere.
I let mine warm up about 2 minutes before riding off,also I check the coolant,oil level,tyre pressures,and sometimes I will wipe the tyres with a rag to wipe off leaves and dirt etc,so I can check there are no nails or other nasties in the tyres.
Pre ride checklist consists of what was said above.
As far as warming up goes, shouldn't be longer than the time it takes to put on helmet and gloves. Just ride it gently and keep the revs rather low till you start approaching normal operating temp.
Long idle warm ups will most probably do more harm than good.
Cold engine at idle = low oil pressure, exactly what you don't need on a cold block/valve train
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks