where would i get a clutch cable made

[Pixie]

You can get those tiny little butane pen torches from DSE for about $30-40 IIRC. Those would have enough grunt, wouldn't they?

You can get a gas soldering iron/hot air source/torch for under $25 from Jaycar.

Mt eden motorcycles sell inner cable and nipples to DIY

Use liquid flux (like Duzall ) and hard solder Not electrical solder ( available from Cory's)

[JimO]

got a whole bike with running engine, good tyres, etc for $150 so that will become a donorcycle

[imdying]

So you're all sorted mate?

[awayatc]

The aftermarket parts shop here has multifit cables for sale....various nipples that u can solder on...Our local automotive electrician sell the brass nipples for 50 cts each. And I have done em on the BBQ gas burner before...works,
I have also fixed the clutch end off a cable successfully with a brass screw type clamp from an old powerpoint/plug...
Good luck, shouldn't be to hard....

[imdying]

A BBQ gas burner would be perfect

[Ixion]

I used to use Mum's gas stove. Worked well, though it was a very dangerous practice . Only safe to do when Mum was out !

[Waxxa]

I've had cable's repaired on the spot at Atomic wreckers in Barrys Point road on the north shore. Try them.

[JimO]

So you're all sorted mate?

yes thanks for all the advice