Forget the UK rags, here's good old Motorcycle Daily, eight months ago, showin' how to do it for free!
I commented to one of the Buell engineers after the first day that the bike seemed to react instantly to steering inputs, without any perceptible chassis "wind up". From the front axle through those huge 47mm fork tubes, steering inputs seem to travel without hesitation to the rear wheel...
...
That high plateau of torque spread almost evenly over several thousand rpm launches the 1125R out of corners right now . . . while many higher strung, four-cylinder bikes might just be starting to search for their powerband. It does this in a smooth, controlled manner that allows the rider to open the throttle more aggressively and earlier without upsetting chassis balance or risking rear wheel spin.
...
The rear shock seemed to be sprung a bit more stiffly than the fork. When the bike was ridden aggressively, the shock seemed to do its job well, but there was some harshness transmitted by square edged bumps while cruising around.
...
The clutch worked flawlessly at the track. It was almost impossible to upset the 1125R's chassis with aggressive downshifts. I can't say that the vacuum assist method employed by Buell is better than a more traditional "slipper clutch" design, but it is easily as effective as any other slipper clutch I have used.
Y'see what I mean?
That sorta hard info's the shiznit the punters need. It's nice to know that Erik throws a good party, but we'd rather hear how he builds a motorcycle...
Bookmarks