Hey all,
I have a generation 1 B1 rep and its got a banshee 18.5mm carb, blata origami wrist pin bearing, ported engine including cylinder, cases, inlet mani/reed block intake area, modified reed block to open reeds up and , modded exhaust with 10mm cut out of belly to shift powerband, squish at 0.5mm (killer bottom end), i run it on standard pump gas with motul 2t fully synthetic at 25-30:1 and it goes like a bat out of hell front wheel lifting and a weapon of a powerband
Now i'd like to see what figures this puts out on the dyno- do you guys know where in auckland (im in north shore) would be good and cheap to get a small motor like this on the dyno?
Cheers

 
			
 
					
					
 
		
				
				
					 Reply With Quote
  Reply With Quote 
						
					 
						
					
 
				 
				 
				 
						
					
 
						
					

 
				
 
				 
				 Originally Posted by trademe900
 Originally Posted by trademe900
					
 when could we do that,we could gets lots of people together for it that for sure...
   when could we do that,we could gets lots of people together for it that for sure...
				
 
				
Bookmarks