Fork seal alignment?

**Rupe** · 20th September 2008, 20:49

I can't remember which side faces up with the new ones, anyone know?

**barty5** · 20th September 2008, 20:59

Originally Posted by rupecopp

I can't remember which side faces up with the new ones, anyone know?

its ok your bike is only rated 5 out of 10

put the seals in so the flatter surface is facin out the inner side will have a deepish groove in it and a spring that runs round the inside edge.

**barty5** · 20th September 2008, 21:00

ps whats the stall count up to.

**Rupe** · 20th September 2008, 21:05

Originally Posted by barty5

its ok your bike is only rated 5 out of 10:.

Wanker!

So the flat surface faces the bottom/ground?????

I don't know the stall count as I only have 10 fingers

**barty5** · 20th September 2008, 21:09

shit dont you have any toes poor bugger..

Yeh the flat surface should face down the length of the fork towards the outside.

**cheese** · 20th September 2008, 21:46

Need some L plates mate?

tested that drill out?

**Rupe** · 20th September 2008, 21:54

Originally Posted by cheese

Need some L plates mate?

tested that drill out?

Yeah, maybe I could borrow them off your bike smart arse.

I'll give the drill a good run next week, cheers

**barty5** · 21st September 2008, 00:57

Originally Posted by cheese

Need some L plates mate?

tested that drill out?

im sure rupeert had some see pic

**Rupe** · 21st September 2008, 07:42

Originally Posted by barty5

im sure rupeert had some see pic

Anyone know how to give bad rep???? You got me there

**Hemex** · 22nd September 2008, 11:36

Originally Posted by barty5

im sure rupeert had some see pic

hahahahha.. nicely done!!

Thread: Fork seal alignment?