Daytona minimoto mods...

[Ray LeCheminant]

Pics or it didn't happen...

Good luck getting the carb floats to work

[mr_penguin]

Out of interest have you guys gone to the local kart club to see if you can get access to there track ????

Thats if there is a club down there..

[imdying]

Good luck getting the carb floats to work

Ok, I'll bite... why would the float work worse than it normally does due to their changes?

Out of interest have you guys gone to the local kart club to see if you can get access to there track ????

Sadly, never gonna happen... those guys have a hard enough time as it is with stupid wankers that live nearby bitching.

[Nutter34]

Out of interest have you guys gone to the local kart club to see if you can get access to there track ????

Thats if there is a club down there..

We had the buckets running a few years ago for maybe two or three months. Then the kart guys canned it.

I wouldn't bother dealing with them again.

A DREAM of mine is to win millions, build the most awesomest of kart tracks but deny the local kart guys access to it, lol...

[Nutter34]

Good luck getting the carb floats to work

I'm with Imdying... Please explain the logic.

The base of the motor is exactly the same. All that has changed is the barrell orientation. The carb is sitting exactly where it was before...

[imdying]

You thinking 4 stroke Ray?

[Ray LeCheminant]

You thinking 4 stroke Ray?

Maybe I need to roatate a barrell on ours and take a gander - I just looked at it, and it stumped me, you know me ...confused state of affair...

If it works awesome - ramed intake have got to be a massive benefit

[imdying]

Maybe I need to roatate a barrell on ours and take a gander - I just looked at it, and it stumped me, you know me ...confused state of affair...

If it works awesome - ramed intake have got to be a massive benefit

Remember the carb bolts to the reed block, which bolts to the cases, and you're only turning the barrel.

'Ram air' wouldn't help, the air in the inlet tract has mass, and the speed a mini moto travels out isn't sufficient to generate any pressure there.

[Ray LeCheminant]

Remember the carb bolts to the reed block, which bolts to the cases, and you're only turning the barrel.

'Ram air' wouldn't help, the air in the inlet tract has mass, and the speed a mini moto travels out isn't sufficient to generate any pressure there.

Yaah I figured that out after I posted....LOL - must be getting confused with the 4 Stroke.....haven't touched the Minimoto for so long now