have a slight issue.
Bik just had new top end, and has been run three or four times since the rebuild - each time only for about 5-10 minutes.
The other day I put an hour meter on it, and fired it up, no problems.
Next day, I wanted to take it out. I fired it up without an issue, and let it warm up, it was warming up fine for about 5 minutes or so, and as i was walking towards it to get on it, it died and wouldnt start.
I have tried removing the spark plug and kicking it over in case it was flooded,
checked the plug (which was new with the rebuild) and it is clean
spark is a strong blue spark
pulled carbs apart and cleaned and rechecked float height
still wont start
tried whipping the plug out and throwing some fuel down the hole and plug back in and kicking it over, - no go
just pushed it to the top of a big hill and tried to bump start it coming down, to no avail.
The best I managed coming down the hill was it would fire once every 10 or 12 revolutions.
what am i missing here?
1991 CR 125
Bookmarks