CBR150 motors

**RMS eng** · 7th April 2013, 19:55

Originally Posted by kel

I call BULLSHIT. Replace the wooden blocks with bungy cords and you might get close

only if no mates bike at 75KG is bullshit ,thats what he told mark his bike was,as i have had a RGV125 motor the same as a RG150 and they are 25kg the CBR150 is 24kg.

**jasonu** · 8th April 2013, 14:12

Originally Posted by kel

I call BULLSHIT. Replace the wooden blocks with bungy cords and you might get close

NX4 RS125 weighs 71kg half wet. The CBR150 motor weighs nearly 6kg more than the RS 125 motor. Add it up, 76kg is not unrealistic.

**F5 Dave** · 8th April 2013, 14:21

Thats pretty impressive. But bet it makes a crap noise.

**kel** · 8th April 2013, 17:06

Originally Posted by jasonu

NX4 RS125 weighs 71kg half wet. The CBR150 motor weighs nearly 6kg more than the RS 125 motor. Add it up, 76kg is not unrealistic.

you guys have no sense of humour, and very short memories

**jasonu** · 9th April 2013, 01:26

Originally Posted by kel

you guys have no sense of humour, and very short memories

Na mate, I know what you are refering too. Just stirring the pot you know.
Good luck at the GP.

**RMS eng** · 20th April 2013, 17:53

Originally Posted by jasonu

Na mate, I know what you are refering too. Just stirring the pot you know.
Good luck at the GP.

motor No 3 RG50,hope to make mounts to fit all three motors,KERG100 CBR150 RG50,see which one is best

**F5 Dave** · 20th April 2013, 21:41

Come play with the boyz!@

**RMS eng** · 21st April 2013, 19:24

Originally Posted by RMS eng

motor No 3 RG50,hope to make mounts to fit all three motors,KERG100 CBR150 RG50,see which one is best

this is how the CBR and KE100 motors will have to fly in this frame,have done drawings for top motor mounts on all 3 motors and will make set up mount from 3mm alloy next week when i get my new jig saw.making and fitting the pipe for the KE100 set up will be NO fun.

**jasonu** · 15th November 2014, 17:32

Originally Posted by RMS eng

this is how the CBR and KE100 motors will have to fly in this frame,have done drawings for top motor mounts on all 3 motors and will make set up mount from 3mm alloy next week when i get my new jig saw.making and fitting the pipe for the KE100 set up will be NO fun.

Slow progress. Is it next week yet? ??

Click image for larger version.

Name: 1416029351790.jpg
Views: 47
Size: 768.8 KB
ID: 305364

**bucketracer** · 13th December 2014, 16:30

How is the engine fitting going? Will you be using the CBR or RG50?

**jasonu** · 14th December 2014, 06:33

Originally Posted by bucketracer

How is the engine fitting going? Will you be using the CBR or RG50?

RG50 first. It is the easiest to fit. 2nd will be the RGKE 100 motor. It is a proven donk that makes good fat hp and doesn't seize when the throttle is opened (or closed). The CBR is at the bottom of the list. We are keeping an eye out for a CBR150 rolling chassis...