Page 4 of 5 FirstFirst ... 2345 LastLast
Results 46 to 60 of 61

Thread: People selling bikes!

  1. #46
    Join Date
    17th June 2010 - 16:44
    Bike
    bandit
    Location
    Bay of Plenty
    Posts
    2,885
    Quote Originally Posted by Drew View Post
    So, I saw this on here. http://www.kiwibiker.co.nz/forums/sh...R-600-for-sale And thought it was quite a bit over priced. Went to have a look what other muppets are selling them for, and when clicking "other stuff you might like", found this gem.
    http://www.trademe.co.nz/motors/moto...-604203397.htm

    200Hp? I bloody don't think so! Q and A made me laugh.

    Anyhoo, just thought I'd post to get my count up a bit more.
    Have you seen the comment from lauren21 in this sale ??? has just got a full licence and wants to upgrade from a Ginny - will this have more go?

    Bosslady - is that you being a stirrer ???
    "So if you meet me, have some sympathy, have some courtesy, have some taste ..."

  2. #47
    Join Date
    5th April 2004 - 20:04
    Bike
    Exxon Valdez
    Location
    wellington
    Posts
    13,381
    I love this answer, to the current last question.

    Q "Factory HP figures are done on a test bench with a test engine, HP figure measured at the crank. In the real world, a K9 1000 is around 170 plus or minus. A can on a 4 to 1 link on the header will do little to change that, unless mapping is done on the dyno. My K9 really does make 200. Ex Robbie Bugden ,a bike he won the NZ Superbike title on.That engine cost more than your bike to build. Consumer gauranties act obliges you be accurate in your description. Post your dyno figures".

    A "So I'm 100% right then.. "in the real world" these are approx 160-165at the wheel hp, I have said 200hp at the crank..if you use the approx calculation of 15-18% to calculate wheel-crank hp you are looking at a medium average of +26.81 hp extra which gives you 162.5 wheel hp+26.81hp crank conversion + extractors and pipe and filter at approx 5-10hp and here we are at 199.31hp at the crank! .. P.s This is an auction not a forum go txt ya mate Robbin bugden and see if he wants a play date".

    At 18%, it still isn't 200 ponies. And trust me, you don't get 5 horses from a pipe and filter without mapping the ECU differently.

  3. #48
    Join Date
    17th June 2010 - 16:44
    Bike
    bandit
    Location
    Bay of Plenty
    Posts
    2,885
    Yeah .. he sounds like a tosser who knows bugger all ..

    I wonder, because he seems to know bugger all about the bike, if he is selling it because he scared himself shitless on it ... if he rides it as badly as he talks about it ...
    "So if you meet me, have some sympathy, have some courtesy, have some taste ..."

  4. #49
    Join Date
    5th April 2004 - 20:04
    Bike
    Exxon Valdez
    Location
    wellington
    Posts
    13,381
    Quote Originally Posted by Banditbandit View Post
    Yeah .. he sounds like a tosser who knows bugger all ..

    I wonder, because he seems to know bugger all about the bike, if he is selling it because he scared himself shitless on it ... if he rides it as badly as he talks about it ...
    Naaaaah, K9 is a pussy cat of a bike. A fuckin fast pussy cat, but no K5/6 animal that'll eat you alive.

  5. #50
    Join Date
    17th June 2010 - 16:44
    Bike
    bandit
    Location
    Bay of Plenty
    Posts
    2,885
    Quote Originally Posted by Drew View Post
    Naaaaah, K9 is a pussy cat of a bike. A fuckin fast pussy cat, but no K5/6 animal that'll eat you alive.
    OK .. but they're all quicker than anything I own anyway ...
    "So if you meet me, have some sympathy, have some courtesy, have some taste ..."

  6. #51
    Join Date
    5th April 2004 - 20:04
    Bike
    Exxon Valdez
    Location
    wellington
    Posts
    13,381
    Quote Originally Posted by Banditbandit View Post
    OK .. but they're all quicker than anything I own anyway ...
    The speed will do anyones head in, that thinks too long about it. Don't get me wrong.

  7. #52
    Join Date
    8th November 2005 - 12:25
    Bike
    Aprillia RSV1000R 92 KX500
    Location
    Waverley, kind off
    Posts
    2,406
    Blog Entries
    4
    My experience is a fast bike only feels fast until some prick passes you going a few km's faster, then said fast bike feels like a slow dog
    And yeah, 200 hp at the crank for a pipe n filter, ya dreamin mate.

  8. #53
    Join Date
    5th April 2004 - 20:04
    Bike
    Exxon Valdez
    Location
    wellington
    Posts
    13,381
    Quote Originally Posted by sugilite View Post
    My experience is a fast bike only feels fast until some prick passes you going a few km's faster, then said fast bike feels like a slow dog
    And yeah, 200 hp at the crank for a pipe n filter, ya dreamin mate.
    Yip. My thou was fine, right up untill Dion Sellers rode away from me on a straight bit while my speedo was pinned at 299. (That's as high as the K2 gixxer speedo went, the rev counter would continue to climb. (Yes, I am aware the speedo was optimistic)).

  9. #54
    Join Date
    31st March 2005 - 02:18
    Bike
    CB919, 1090R, R1200GSA
    Location
    East Aucks
    Posts
    10,516
    Blog Entries
    140
    When I purchased my 04 ZX10R, I was told the seller had babied it. He's describing the bike, saying it kills the R1s, and he's disappointed he's only had it up to 270. I'm thinking shit, no way was this babied.

    Then he shows me the rear tyre, and says, but I never could wear away the last inch on the side of the tyre

    Later on I swapped the tyres when worn for something with a better profile... the stockers were too flat and I ran off the edge too much
    Quote Originally Posted by Jane Omorogbe from UK MSN on the KTM990SM
    It's barking mad and if it doesn't turn you into a complete loon within half an hour of cocking a leg over the lofty 875mm seat height, I'll eat my Arai.

  10. #55
    Join Date
    21st January 2010 - 12:21
    Bike
    The Black Pearl
    Location
    Vegas Az
    Posts
    1,468
    Blog Entries
    3
    I just spotted this one in a listing


    Rego is on hold and she will need a new wof.

    There is some minor rust but all in all the bike is a good runner.She recently had an oil change so is all ready to go through a wof.
    Keep on chooglin'

  11. #56
    Join Date
    3rd January 2013 - 19:46
    Bike
    1999 Honda Hornet CB600FX
    Location
    Taupo
    Posts
    709
    The description in this ad is awesome: http://www.wheedle.co.nz/Home/GetIte...0TiQ%253d%253d
    'Masochists edition'

    Goes with this thread: http://www.kiwibiker.co.nz/forums/sh...-%28GSXR250%29

  12. #57
    Join Date
    9th January 2008 - 12:01
    Bike
    Custom Ag100
    Location
    The Tron
    Posts
    1,443
    Dreamin' or what?

    18k for a 2002 cbr600.........

    http://www.trademe.co.nz/a.aspx?id=678196541
    "Sorry Officer, umm.... my yellow power band got stuck wide open"

  13. #58
    Join Date
    20th June 2011 - 20:27
    Bike
    Dog Rooter, 1290 SDR
    Location
    Marton
    Posts
    9,854
    Quote Originally Posted by BigAl View Post
    Dreamin' or what?

    18k for a 2002 cbr600.........

    http://www.trademe.co.nz/a.aspx?id=678196541
    Im sure that bike was for sale at Botany Honda a year back for 7k.

  14. #59
    Join Date
    17th July 2005 - 22:28
    Bike
    Dougcati, Geoff and Suzi
    Location
    Banjo town
    Posts
    10,162
    It says it has a lot of other stuff, so worth it.
    Quote Originally Posted by Paul in NZ View Post
    Ha...Thats true but life is full horrible choices sometimes Merv. Then sometimes just plain stuff happens... and then some more stuff happens.....




    Alloy, stainless and Ti polishing.
    Bling your bike out!
    PM me

  15. #60
    Join Date
    15th November 2008 - 07:27
    Bike
    vfr400 NC30, SRX600 project
    Location
    Glen Eden, Auckland
    Posts
    1,120
    Quote Originally Posted by ducatilover View Post
    It says it has a lot of other stuff, so worth it.
    Lol...Tui.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •