Optimistic sellers

[husaberg]

Linky no worky

Hold on to your Hat And be prepared to mortgage the Mrs Pumba
http://www.trademe.co.nz/motors/moto...-995203579.htm

[EJK]

Hold on to your Hat And be prepared to mortgage the Mrs Pumba
http://www.trademe.co.nz/motors/moto...-995203579.htm

Optimist Of The Month goes to...

[husaberg]

Optimist Of The Month goes to...

Maybe it was meant to be in Yen or Pasos........
I like it, esp the wheels and styling that are TZ/RD400ish, but maybe $5000 like considering the amount of aftermarket stuff like the FCR carb, not over 4 times that price.

here is one on the net
http://kickstart.bikeexif.com/wp-con...a-sr500-51.jpg

but wouldn't this be so much better

[Pumba]

Hold on to your Hat And be prepared to mortgage the Mrs Pumba
http://www.trademe.co.nz/motors/moto...-995203579.htm

Yea, nah. More so nah. Actually quite a lot big nah.

[Askor]

but wouldn't this be so much better

[Autech]

True,..but they pretty rare nowadays. A lot rarer than the NC30s.
And that 180 crank sounds great at 14,000rpm !!

But yes,..$1.5-2K cheaper would be worthwhile.

Can't argue with you there, my NC24 turns head at the track with it's ROAR! Had a mate say last round that he knew it was me behind him cause he heard me there. That's with ear plugs and on top of a ZX10r lol. That was until he hit the straight and fucked off for the remainder of the race

[OddDuck]

Hold on to your Hat And be prepared to mortgage the Mrs Pumba
http://www.trademe.co.nz/motors/moto...-995203579.htm

Gonna be fussy here... hasn't he got the floating rear brake on upside down? Every other bike I've ever seen with one has it under the disk and pulling at the rear of the bike, not above and pushing.

[Scubbo]

http://www.trademe.co.nz/motors/moto...-996052718.htm

[flashg]

Gonna be fussy here... hasn't he got the floating rear brake on upside down? Every other bike I've ever seen with one has it under the disk and pulling at the rear of the bike, not above and pushing.

Have a closer look, you'll see the word "brembo" is the right way up and the bleed valve is at the top (where it should be) you'll find many bikes have the rear caliper on top. The pads gripping the disc is the main thing.

[TheDemonLord]

Have a closer look, you'll see the word "brembo" is the right way up and the bleed valve is at the top (where it should be) you'll find many bikes have the rear caliper on top. The pads gripping the disc is the main thing.

was gonna say - My 'Busa has the rear Caliper on the top.

[flashg]

My Yamaha 2011 XT660Z Tenere.

[flashg]

My Beta 300RR 2014

[flashg]

My 2012 Yamaha WR 450

[flashg]

Apology's those photos are all on the side, but they were fine when i took them

[F5 Dave]

Oh matey potaty. Those SR500s are good for 27-28hp and there's a lots of piston and carb right there. You'd be spinning high 30s no doubt. Rip your arms out.