I was undecided about which make of soft panniers to buy when Clint and Rosie recommended the Andy Strapz ones, based on a few years of good service from theirs. So I bought them and used them with good results on an overseas trip but now I want to fit them to my DR, so I need a rack. But here's the rub I dont really like the look of the Andy Strapz racks they look a bit spindly to me. The Wolfman ones look tougher and the shape is more pleasing to me. Anyone fitted Andy Strapz panniers to a Wolfman rack? I am going to need a rear rack as well, preferably one that has some grabrail capability. Any NZ options? Any recommendations?
www.AdventureRidingNZ.co.nz NZ's dedicated Adventure Riding Community
Forums, free GPS track downloads and much more. Now over 5700 members, are you one of them?
With a bit of tweaking of the straps and clips, I imagine the andystrapz bags would fit onto most racks designed for soft bags. We've had ours on four different sets of home-made racks (all designed differently) without any trouble - although the bags sit a lot better if they don't sit too far below the bottom of the rack, so the side of the bag is well supported.
I can get some photos of my modified attachment points, if that would give you ideas of how the bags might be easily fiddled to fit onto a different set of racks.
The road to hell is paved...
Eddie TVM for the offer and will plan to take you up on that just need to check kids are sorted with my ex. Yes I am onto the tank will get out to mate's house next couple of days and retrieve the tank and send you some pics.
Rosie TY to you as well. Will see which way I decide to go and then will take you up on your offer. You guys coming up for the Coromandel trip this w/e?
Recently bought a DR650 and at the stage of adding a few goodies - screen, sump guard, luggage rack, bar risers so far and just about to add some lever protection in the form of Zeta protectors. Before I munt the throttle side I thought I'd ask for advice. What's the story with getting in to the bar end after removing the weight - there's a rubber washer and a solid threaded part in to which the end weight screws in to. Can anyone tell me how to remove this in order to replace with the Zeta screw and spreader device. Thanks in advance![]()
www.AdventureRidingNZ.co.nz NZ's dedicated Adventure Riding Community
Forums, free GPS track downloads and much more. Now over 5700 members, are you one of them?
Iirc you just loosen the screw on the end and that uncompresses the rubber bit allowing you to pull it out... You can usually fish the other bits out with wire if they're stuck inside
Wolfman saddlebags
Hey Guys, just another thought for those that are looking at equipping their bikes with soft panniers, to eliminate the need for racks ect, consider looking at the "Coyote Giant Loop Bag". They sell for about $500NZ and need to be bought out of the States. I have however used one as a template, did some mods on the one I had made, and it fits and works a treat. I can have these made for $300NZ with a two week delivery. Just a thought anyway.
Life is about having fun.
Thanks to everyone who has responded re luggage etc. Planning on getting to the Coromandel ride this weekend so will check out your racks then Eddie pnaar pnaar!
I use the cheap Oxford jobs. Just pull them forward onto the plastic side cover.
They expand out quite a way, and keep the weight low and forward.
![]()
This looks like a fairly good deal.
http://www.trademe.co.nz/motors/moto...-414830141.htm
By my calculation reserve is about $5150
![]()
www.AdventureRidingNZ.co.nz NZ's dedicated Adventure Riding Community
Forums, free GPS track downloads and much more. Now over 5700 members, are you one of them?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks